![]() To do this, weave a figure eight on the first two beginning pegs. Now that you’ve completed your cast-on, start the first row by completing the turn. Keep repeating this pattern for each loop until you return back to the first peg.Īfter reaching the first peg, one tip I like to use is to push the yarn down the peg to the halfway point to give yourself some working room. Take your loom pick, bringing the bottom loop up over the top loop of yarn to secure it. Now wrap the yarn around each peg in a clockwise direction. After doing this you have now reached the turn, where you will need your yarn hook. Once you get to the last peg, wrap the yarn twice around it so that it faces the direction it came from. Finishing Your Cast-On: Wrapping the Return Row A general rule of thumb I like to follow is to loop up six pegs on each side of the loom for an average width scarf. Keep in mind that once you finish the scarf and remove it from the loom, it will be slightly more narrow. To make the scarf thinner, use fewer pegs. ![]() To make the scarf wider, I like to use more pegs, usually around 8-9. About halfway down each peg, wrap the yarn, (all the way around the loom for an infinity scarf), or halfway around the loom for a classic single layer flat scarf. Now catch the yarn around behind the first peg to the left of the anchor peg. Getting Your Cast-On: Attach Your Yarn to the Loomįirst, you will need to tie one end of the yarn to your anchor peg, which is the peg on the outside of the loop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |